Product Data Sheet Show all documents

Davco® Dustless Regular Tile Adhesive

It is used for standard sized tiles and all porous tiles such as ceramic tiles, ceramic mosaics and baked clay tiles.

  • Can be used for internal and external floors, internal walls (for consulation, depending on tile size)
  • Easy to use; just mix with water
  • Non-toxic, non-flammable
  • Easy mixing and tiling; saves time and cost
Product Data Sheet Show all documents

Usage

Davco® Dustless Regular Tile Adhesive is an economical thick or thin bed (TTB) cement based tile adhesive. Ideal for laying the following tile types: ceramic tiles, baked clay tiles, quarry and most monocottura tiles unto interior and exterior walls and floors.  

Advantages

  • Can be used for internal and external floors, internal walls (for consulation, depending on tile size)
  • Easy to use; just mix with water
  • Non-toxic, non-flammable
  • Easy mixing and tiling; saves time and cost

Packaging

25kg

Colour

Gray

Product Details

Product Information

Chemical Base

Cement, selected aggregates

Shelf Life

12 months from date of production if stored properly

Storage Conditions

Store properly in unopened and undamaged original sealed containers protected from direct sunlight & moisture at temperatures between +10°C and +35°C.
Technical Information

Tensile Adhesion Strength

28 days by Pull-off test ASTM C1583: ≥ 0.5 MPa (at 24% water-to-powder ratio)

Application

Application Information

Pot Life

1-2 hours

Open Time

20 minutes

Curing Time

24 hours

Fresh mortar density

1.6 - 1.7 kg/ L

 
Application steps

SURFACE PREPARATION

All surfaces must be structurally sound, dry, clean and free from oil, grease, wax, and other contaminants. Painted surfaces must be scrubbed/abraded to expose at least 75% of clean surface. Newly rendered surfaces must be allowed to cure for at least 7 days. Steel trowel finished concrete must be acid-etched or wire brushed prior to tiling. Very porous surfaces should be properly primed. New concrete must be allowed to cure for 28 days.

MIXING

Add one 25 kg bag of Davco Dustless Regular Tile Adhesive to approximately 5 to 6 liters of clean water, mixing continuously until a lump-free, creamy consistency is achieved.

 

APPLICATION

Allow the mix to stand for 1-2 minutes; remix then use the adhesive. Spread the adhesive onto the substrate using either a 6mm x 6mm notched trowel for wall tiling, or a 10mm x 10mm notched trowel for floor tiling. The choice of trowel should be determined by the size of the tiles, depth of knobs, grooves or ridges on the back of the tile, and the evenness of the substrate.

  • A 6mm x 6mm notched trowel is recommended for the mosaic tiles.
  • Thicker bed adhesive allow for better contact to the substrate as well as picking up unevenness especially in the case of slates.
  • For tiles with deep grooves or ridges, such as slate or lugged backed tiles, the adhesive should be butter coated onto the back of the tiles in addition to being notched-trowelled onto the substrate.
  • Do not spread more than 1 m2 of adhesive at a time.
  • Ensure that the adhesive is wet when the tiles are laid and tapped into position to ensure positive contact with the adhesive.
  • Ensure that there are no voids under the tiles.
  • Do not allow the adhesive to skin over prior to tiling.
  • Install tiles within the duration of the open time. Do not disturb or walk-on tiles within 24 hours, after installation.

Documents