Product Data Sheet Show all documents
SikaPlast-2000 P4

SikaPlast-2000 P4

3rd Generation Low-mid Range Super plasticizer

SikaPlast -2000 P4 is a third generation low-mid range super plasticizer for concrete and mortar. It meets the requirements for super plasticizers according to ASTM C494 type G.

SikaPlast -2000 P4 acts by different mechanisms. Through surface absorption and sterical separation effect on the cement particles, in parallel to the hydration process, the following properties are obtained:
  •  High water reduction (resulting in high density and strengths).
  •  Excellent flowability (resulting highly reduced placing and compacting efforts).
Product Data Sheet Show all documents

Usage

SikaPlast -2000 P4 is suitable for the production of site mixed as well as ready-mix concrete. SikaPlast -2000 P4 is used for concrete with extended transportation or placing time. SikaPlast -2000 P4 facilitates good water reduction,    excellent flow properties, optimal cohesion and highest self-compacting behavior. SikaPlast -2000 P4 is used for the following types of concrete:
  •  Hot weather concrete and concrete with extended transportation - or placing time
  •  Concrete with highest water reduction   (10-15%   typical)
  • High strength concrete.
  •  Grade 20-40mpa low medium-high workability concrete, 75 mm - 200 mm slump.
High water reduction and excellent flow ability have a positive influence on the above mention applications.  

Advantages

SikaPlast -2000 P4 acts by different mechanisms. Through surface absorption and sterical separation effect on the cement particles, in parallel to the hydration process, the following properties are obtained:
  •  High water reduction (resulting in high density and strengths).
  •  Excellent flowability (resulting highly reduced placing and compacting efforts).

Packaging

210 L drum & 1,000 L Bulk

Colour

Brown Liquid

Product Details

Product Information

Chemical Base

Polycarboxylic polyether type polymer

Shelf Life

12 months from date of production if stored in unopened, undamaged original container

Storage Conditions

Protect from direct sunlight at temperatures between +5o C and +35o C

Specific Gravity

1.08 ± 0.02 kg/L
Technical Information

Concreting Guidance

With the use of SikaPlast -2000 P4 concrete of highest quality is being produced. The standard rules of good concreting practice (production as well as placing) must also be observed with SikaPlast -2000 P4 concrete. Fresh concrete must be cured properly.

Application

Application Information

Dispensing

SikaPlast -2000 P4 is added to the gauging water or simultaneously poured into the concrete mixer. For optimum utilization of the high water reduction we recommend thorough mixing at a minimal wet mixing of 60 seconds. The addition of the remaining gauging water – to fine tune concrete consistency may only be started after 2/3 of the wet mixing time, to avoid surplus water in the concrete.
Consumption

Recommended Dosage

1.0% - 2.0% by weight of total cementitious binder
Application steps

APPLICATION INSTRUCTIONS

When using SikaPlast -2000 P4 a suitable design has to be taken into account and local materials sources shall be trialled. SikaPlast -2000 P4 shall not be added to dry cement. Excessive water addition or overdosing may cause bleeding or segregation.

Documents