Product Data Sheet Show all documents

Sika® Formol-EX

Chemical Form Release Compound for Precasters

A chemical release agent for use on both wooden and steel molds.

Sika® Formol-EX can be applied by either spray, brush, or roller. Surfaces should be clean and free from greasy and old concrete.  
Product Data Sheet Show all documents

Usage

Sika® Formol-EX can be used with excellent effect on formwork designed to produce all types of finishes, from fair-faced to textured. Sika® Formol-EX has been found to assist in the protection of equipment used in the handling and placing of concrete. A thin coating on Bowls, Barrows, Skips, Shovels, etc. will make these easier to clean and protects against corrosion.

Advantages

Sika® Formol-EX can be applied by either spray, brush, or roller. Surfaces should be clean and free from greasy and old concrete.  

Packaging

210 Liters drum

Colour

Liquid / Clear to Slightly turbid (colour may vary)

Product Details

Sustainability / Certifications / Approvals

ENVIRONMENTAL INFORMATION

Sika® Formol-EX is flammable and should not be used near naked flame.

Sika® products are generally quite harmless, provided certain precautions normally taken when handling chemicals are observed.

  • Avoid contact with food or food utensils
  • Avoid prolonged skin contact
  • Wear protective clothing

In the event of contamination, wash thoroughly with water.If the eyes or mouth are affected, wash with clean water immediately and obtain
medical attention.Every reasonable precaution is taken in the manufacture of our products and in the compilation of information about them but results cannot be guaranteed. Please consult our Technical Department for further information.
Product Information

Chemical Base

Oil base

Shelf Life

24 months from date of production if stored in unopened and unchanged original sealed containers.

Storage Conditions

Store properly in original, unopened and undamaged packaging in dry conditions at temperatures between +5 °C and +40 °C. Keep away from direct sunlight.

Specific gravity

~ 0.800 - 0.850

 

Application

Consumption

Consumption

Sika® Formol-EX should be applied at the following stated coverage rates to obtain a thin and even film over the entire surface of the mould or formwork.

Timber Formwork

~1 L per 19 m² (0.05 L/m²)

Metal Formwork

~1 L per 30 m² (0.03 L/m²)
Application steps

APPLICATION

Sika® Formol-EX can be applied by either spray, brush, or roller. Surfaces should be clean and free from greasy and old concrete.

CLEANING OF TOOLS

Clean all tools and application equipment with water immediately after use. Hardened and/or cured material can only be mechanically removed.

 

Documents